240 capacitive notes - 95 lights - MIDI reference problem

[LookAt]

Hy everybody,

I'm writing here because I have a problem with a quite huge system that I've build.
The topic was to recreate an organ keyboard with light in a big scale, so I build a keyboard 6mt long 3mt hight build up of 60 glass slice, each with 4 capacitive sensors. Behind each slice I put 2 led stips, the upper activated by the first three capacitive sensors, the lower activated by last capacitive sensor.

In total I have 240 different "note", each group of 12 linked with a total of 20 Touch Board Bare Conductive (https://www.bareconductive.com/collecti ... sLmj8Drpqq). I have then a usb hub to an iMac.
For the lights I used a Entec open DMX USB (https://a.co/d/123OCIL) that drive 3 DMX decoder/controller 32 channels each (some lower note ativate the same light) (https://a.co/d/akMbvUs).

The audio goes with GarageBand, and I build a system in QLC+ with 20 different universes, one for each Touch Board. Everything works fine.
The problem come when the systen is shutted down due to power problem. When the system restart, I have to reconfigure each universe to the correct Touch Board.

I put an UPS but I want to modify the QLC+ program to work as GarageBand, so when the system restart I don't have to relink all the Touch Boards.

I was wondering if there is a method with I can say to QLC+ to read from all the Touch Boards toghether the correct MIDI code.
Is it possible? Can someone help me?

Thank you all in advance,
Luca

[mcallegari]

[moderator] please read the "community" section description before posting. It's definitely the wrong place to post a support request. Moved this post to the proper area

[GGGss]

When connected, does your Touch Board Bare Conductive reveal a serial number inside QLC+? If so, there might be a solution. Explanation: the USB bus refreshes upon startup. It doesn't respect any order of USB devices attached. So QLC+ cannot possibly know where to look for device #4. Unless a serial number is revealed, you may ask Massimo to do a code tweak so QLC+ remembers the serials of your attached devices.