Page 1 of 1
Generic dimmers and functions
Posted: Mon Oct 14, 2024 10:31 pm
by EORTTD
I picked up some old Leviton dimmers and I am using a DMX to 0-10V convert to run them. When I use the simple console, I can see the dimmers and control them, but when I use the generic dimmer fixture, it does not work in functions. Not sure what to do here since I am relatively new to QLC. Thanks!
Re: Generic dimmers and functions
Posted: Tue Oct 15, 2024 8:15 am
by GGGss
Welcome to the community,
If you switch from Simple Desk to anything else, make sure there are no red 'X's present. Simple Desk has the utmost priority. Even a slider at zero, will overrule anything else.
If you can control your lights with the sliders in Simple Desk, you should be able to do so with a generic dimmer. (At the correct address that is.)