Q Light Controller+

I recently bought these light and had to make their profile. I believe I did everything right as everything works as expected when I plug them in to power and DMX. But in 2D View, they only ever show as black or off. What am I doing wrong?

The problem is in your Fixture Definition.
Both your Dimmer and Strobe channel are set as Intensity, so basically you have two Master Dimmer Channels. QLC+ cannot handle that.

Try this one:

If you would have used the on line Fixture Vallidator ( https://www.qlcplus.org/fixture_validator.php ), it would have given you the following Message:

ERROR: channel <Strobe> group should be set to 'Shutter'