Flash scene with fade out > 0 causes scene to go dark
Posted: Tue Aug 13, 2024 12:58 am
QLC 4.13.1
I read a lot about the flash fade issues, but I don't know if it is exactly the behavior I seen.
1. Create simple scene 1+ fixtures.
2. create scene for flash (all white)
a. set fade out to 500ms
3. Create buttons for each scene and mark Flash.
Start show and select scene to be set. Press Flash button and flash shows, but when released it follows the fade out value of the flash scene and when at 0 it does not go back. It should do a cross fade back to where it was.
NOTE: If you use speed dial on your virtual desk to control fade and this scene is part of that list it will be modified and stop working again.
I read a lot about the flash fade issues, but I don't know if it is exactly the behavior I seen.
1. Create simple scene 1+ fixtures.
2. create scene for flash (all white)
a. set fade out to 500ms
3. Create buttons for each scene and mark Flash.
Start show and select scene to be set. Press Flash button and flash shows, but when released it follows the fade out value of the flash scene and when at 0 it does not go back. It should do a cross fade back to where it was.
NOTE: If you use speed dial on your virtual desk to control fade and this scene is part of that list it will be modified and stop working again.