Q Light Controller+

I know people have asked about this specific controller before, but I've tried and maybe I'm not super technical enough to get it. I am working with a SP801E I got on amazon to create an LED Panel. I can use JINX! fine with it and everything works great, but when I try to connect QLC+ to this controller to make a panel, I can not get it to work. I created a panel 70 pixels wide by 8 tall across 4 universes. Each row of 2 tied to a universe.

QLC can see the node, but I just can't figure out what's wrong here.

You may have to try changing the transmission mode. It could be that your Artnet controller doesn't like the standard mode.
More about modes here: https://docs.qlcplus.org/v4/plugins/art-net

Hi!

I am struggling with a very similar setting (19x30 RGB Pixels split into 3 universes) and found an interesting effect: If I use the App that came with the SP801E ("BalanX"), all channels work just fine. The moment I switch to Artnet, they stop working. However, if I only address one universe at a time, it works just fine.

From what I have read in this forum and on the QLC+ documentation about Artnet, I suspect it to be a problem of data bandwith. Frankly speaking, I never trusted this tiny device to be capable of doing WIFI and LED controlling and Artnet processing at once. If my suspicion is right, changing the Artnet Mode might make a difference. Did you try that?

I don't have the device here, its in our rehearsal room but I will definitely try this and let you know.

Cheers,
Chris

In the above picture, the user shows its Artnet configuration. The Artnet universes 2-5 are being used. For this to work, you must alter the Artnet configuration in QLC+ so that f.i. universe 1 does send Artnet to Artnet Universe 2 and so on... https://docs.qlcplus.org/v4/plugins/art-net