Q Light Controller+

Hi!

I would like to invert just the simulated movement in the 3D Viewer. I use QLC4 and send the DMX data to QLC5 so I can see it in the 3D Viewer.

The problem is now that I can't use the invert for the channel because my Showtec Phantom 180 Wash does the invert itself.

Because of that I want to know if I can invert the movement with the 3D Viewer or in QLC5 but not that 0=255.

Thanks and have a nice day!
Zugprofi / Till

Hi,

A bit late to the party, but this is how I did it: (using the same concept: run show in v4 for now, and visualize in v5 dev build)

M.