Q Light Controller+

Hi everyone!
I am using QLC+ with version 4.13.0 and im running in some problems.

If I create an RGB matrix and I try to save starfield with randomizer to a sequence, only the first 2 steps are copied. I want a larger number so I can display this for about 20 seconds. Even when I try to throw the RGB Matrix into my show field, I still cannot indicate how long it should allow this randomizer of the starfield effect to run.





Thanks for the help! I am very happy with how this program works outside of this.

Welcome to the forum,

This is odd. I just tried 4 RGB effects, and depending on which pattern you choose, the save-to sequence gives me 10, 64, and 1024 steps.
What pattern did you choose? There is only the 3D starfield - but there is no 'randomiser'...
The 3D starfield indeed only creates a 2-steps sequence.

If you forget the sequence and insert the RGB Matrix into the show you have two options for duration.

1. Adjust the original to the correct length using 'hold'
2. Select the block in the show and from there you can loop or stretch to fit.