EFX off-set interval range auto-patch
Posted: Fri Jul 19, 2024 4:05 pm
Hello everyone.
I wanted to request the following feature (already requested on Instagram direct to QLC+ but I wanted to make the request public):
The ability to auto-patch the offset degree range between each fixture in an EFX group.
The main reason is one:
If I have 60 moving heads in a group, for example, it will take me a long-long time to manually set the degrees offsets between each fixture, for a very "time-spending" operation for 1 single EFX and for an automation that could be done in 10 seconds instead of many minutes manually.
I know this feature has already been embraced with enthusiasm. I hope it will be added.
Thank you very much, I look forward to reply.
I wanted to request the following feature (already requested on Instagram direct to QLC+ but I wanted to make the request public):
The ability to auto-patch the offset degree range between each fixture in an EFX group.
The main reason is one:
If I have 60 moving heads in a group, for example, it will take me a long-long time to manually set the degrees offsets between each fixture, for a very "time-spending" operation for 1 single EFX and for an automation that could be done in 10 seconds instead of many minutes manually.
I know this feature has already been embraced with enthusiasm. I hope it will be added.
Thank you very much, I look forward to reply.