Q Light Controller+

Hi I have just got 6 of these and they are 8 channels per fixture. It shows in the manual
1- red
2 - green
3 - blue
4 - white
5 - dimmer

6,7,8 are stobe and a few other setting that don’t look like they do anything other than presets

When I added them in turns out 1 is the dimmer and 2 red 3 blue so on. I have found a fixture with the same amount of channels and that has the dimmer in 1 instead of 5 but just wondering why that’s the case if the manual shows it the other way. Also does anyone know how to stop the fixtures from flickering when I’m moving my mouse or doing anything on my PC doesn’t happen all the time just every now and then. Thanks

Beamz always carry 2 chars & 3 digits in its name - So Flatpar 154x10 isn't the one
* Manual mismatch - are you looking for the right type?
* Mode mismatch - is the fixture set to the corresponding mode

* off topic: flickering by using your mouse -> DMX interface problem (need a separate thread started) - in short: change the DMX output frequency.