Lixada udmx stopping after a few seconds

[nostral]

My lixada uDMX adaptor works only for about 20 seconds on my new windows 11 machine. Even without a scene. It just stops sending signal for some reason. The light on the adaptor changes from blue to red, showing that it isnt getting a signal. But QLC still shows it checkmarked as though it is still working. I have disabled windows defender, installed multiple different drivers which device manager says are functioning (they each work for about 20 seconds), tried multiple different of the same adaptors, all with the same result. Ive even installed previous versions of QLC+, and I cant think of anything else to try. I have used these for years without problems. Cant find a driver that works with my enttec. Dont yet have an adaptor to use cat5 to try my Obsydian artnet node - not that I would want to have to buy more of those anyway. I really want to get the Lixadas working. Anyone have any ideas?

[GGGss]

Welcome to the forum,

First off ... did you change or alter the DMX frequency inside the settings of your interface in the in-/output tab of QLC+? You might need to lower the DMX frequency by using the wrench icon. You can verify the condition of the interface. It will show GOOD / BAD.

Cant find a driver that works with my enttec.

Is it now an Enttec of a Lixada?

Dont yet have an adaptor to use cat5 to try my Obsydian artnet node - not that I would want to have to buy more of those anyway. I really want to get the Lixadas working. Anyone have any ideas?

USB-C network NIC: €18 or less... most valuable piece of gear. I don't like wireless at all...