Q Light Controller+

Hi!
I'm very new with this software and and I was wondering if there is a way to create fade in/out WITHOUT all channel of the fixture.
To explain a bit more, I'm using a set of Led Tubes with the following parameters : dimmer, hue, saturation.
When I program a fade in/out, it's acting on every parameters and change my hue and saturation.
So I would like the fade to act ONLY on the dimmer.
Thanks a lot for reading!
Cheers,
Vic

On the Input/Output Tab, Click on the Channel Fade Configuration Icon, then select your Fixture(s) and UnBox "Can Fade" for the Hue and Saturation channels.

Another option could be to create a set of scenes where you only set Hue and Saturation (leave Dimmer UnBoxed) and create seperate scenes that control your Dimmer.
That way you can set Fade In and Fade Out to 0 (zero) for your Hue and Saturation scenes (and still use Fade In and Fade Out for your Dimmer scenes).

[moderator] please read the "community" section description before posting. It's definitely the wrong place to post a support request. Moving to the proper area.