Q Light Controller+

Hello everyone,
I have a question about the show editor.
I have an audio file with a length of 1 minute.
While the audio file is being played, the values on different generic dimmers are slowly increased to 100%.
When the song/show stops, all generic dimmers should keep the last values (100%) at the end. The values should NOT be set back to 0%. The spotlights should remain on indefinitely.
Only when the next show is started should the values be changed again.

Can someone tell me how I can realize this?

Best regards
Jelu

Easiest way to achive this is changing your fixture to LTP mode. https://docs.qlcplus.org/v4/fixture-man ... properties
As long as you don't instruct your fixture to go dark, they will hold their last value. (Latest Takes Precedence)

Thank you!