Q Light Controller+

Hello!
I was wondering if any of you could help me with the fixture: "Steelpro 403-MPR". It's a PAR LED.

I have these pictures of the information: https://forums.pioneerdj.com/hc/en-us/c ... ro-403-MPR

Thank you so much!! It would mean the world to me.

This will get you started:

The Channels and DMX Ranges are all OK, just not sure about the translations off the modes for channels 4 and 5.
Feel free to correct those descriptions (if you ever going to use them).

MichelSliepenbeek wrote: ↑Tue Feb 13, 2024 10:47 pm This will get you started:

Steelpro_403-MPR.qxf


The Channels and DMX Ranges are all OK, just not sure about the translations off the modes for channels 4 and 5.
Feel free to correct those descriptions (if you ever going to use them).

Thank you so much for your quick response and for your help. I really appreciate it.

The closest I could translate Channels 4 and 5 would be:

-Channel 4:
•0-27: No function.
•28-55: Single color Strobe light (Channels 1/2/3 change the color. Channel 6 controls the speed).
•56-83: Multicolored Strobe light (Channels 1/2/3 change the value. Channel 6 controls the speed).
•84-255: Chooses the color.

-Channel 5:
•1-90: Unique color regulator.
•91-103: Automatic dimmer.
•104-116: Automatic dimmer 2.
•117-129: Automatic dimmer 3.
•130-142: Automatic dimmer 4.
•143-155: Color changer 1.
•156-168: Color changer 2.
•169-181: Automatic multicolor 1.
•182-194: Automatic multicolor 2.
•195-207: Automatic multicolor 3.
•208-220: Sound 1.
•221-233: Sound 2.
•234-246: Sound 3.
•247-255: Sound 4.

•Channels 2-4 won't work in this mode.
•Channel 7 controls the speed.

I'll take a look at the file when I get home. Once again thank you!

MichelSliepenbeek wrote: ↑Tue Feb 13, 2024 10:47 pm This will get you started:

Steelpro_403-MPR.qxf


The Channels and DMX Ranges are all OK, just not sure about the translations off the modes for channels 4 and 5.
Feel free to correct those descriptions (if you ever going to use them).

Hello, just wanted to do a quick update. The fixture profile file you shared did work and I was able to gain control of the fixtures.

Now my only issue is that my lights respond to the inputs made on the software, but then after a few seconds they just stop responding.
However, I'm pretty sure that's just an issue with my Macbook and not with QLC+ or the fixtures. It's an old and slow one.

Thank you for your help!

armandoalejos wrote: ↑Thu Feb 15, 2024 6:25 am Now my only issue is that my lights respond to the inputs made on the software, but then after a few seconds they just stop responding.
However, I'm pretty sure that's just an issue with my Macbook and not with QLC+ or the fixtures. It's an old and slow one.

This problem needs a new thread, but my eggs are in the 'DMX interface problem'-basket.