FT232R - Open Rx Receiver State "Idling"
Posted: Sat Jan 06, 2024 8:31 am
Hi everyone,
I've recently realized that from certain version there is "Open Rx" feature, which enables general FT232R USB-RS485 converter to receive external DMX signal. Great work ! (http://www.qlcplus.org/forum/viewtopic.php?t=13489)
However when I tried this feature, in my Mac it works correctly, but in Windows 10 the "Receiver state" is "Idling", does not change to "Receiving".
Is there anything to try to fix this status?
Windows screenshot saying "idling"
-QLC+ 4.12.7
-Windows 10 Pro
-Confirmed Open Tx = sending DMX is working good
-Confirmed signal receiving by the Rx LED on the board, also by a serial monitoring software (Teraterm)
Mac screenshot saying "receiving"
-QLC+ 4.12.7
-Mac OS Monterey 12.6.1 (Intel Mac)
-Confirmed both Open Tx and Open Rx are working good
The screenshots are Japanese version, but you can still read it because the critical part is not translated
I've recently realized that from certain version there is "Open Rx" feature, which enables general FT232R USB-RS485 converter to receive external DMX signal. Great work ! (http://www.qlcplus.org/forum/viewtopic.php?t=13489)
However when I tried this feature, in my Mac it works correctly, but in Windows 10 the "Receiver state" is "Idling", does not change to "Receiving".
Is there anything to try to fix this status?
Windows screenshot saying "idling"
-QLC+ 4.12.7
-Windows 10 Pro
-Confirmed Open Tx = sending DMX is working good
-Confirmed signal receiving by the Rx LED on the board, also by a serial monitoring software (Teraterm)
- image.png (10.36 KiB) Viewed 1995 times
Mac screenshot saying "receiving"
-QLC+ 4.12.7
-Mac OS Monterey 12.6.1 (Intel Mac)
-Confirmed both Open Tx and Open Rx are working good
The screenshots are Japanese version, but you can still read it because the critical part is not translated