Page 1 of 1

Fixture monitor fixture too dim

Posted: Sat Dec 30, 2023 3:36 pm
by maartenvd84
Hi,

I have a little annoyance, yet very logic it happens..
One of the fixtures I'm using has its dimmer channel split into dimmer (1-134) and strobe (135-256).
This causes this type of fixture to look very dim on max brightness in the 2D fixture monitor (compared to the other fixtures).
Sometimes confusing...

Is there a way to get around this?

e.g., two types of fixtures, both at the same intensity level.
TooDim.png
Thx,
Maarten

Re: Fixture monitor fixture too dim

Posted: Sat Jan 06, 2024 3:24 pm
by maartenvd84
Read the complete manual and Channel Modifiers are the way to go it seems:
https://docs.qlcplus.org/v4/fixture-man ... properties
Created a linear modifier that maxes out at 134.
ChannelModifier.png
Will still see how the strobe fuction can be brought back to life, but maybe I can just create a duplicate of that original channel in the fixture definition and assign it also a range (135-200).
Alternative: let QLC+ do the strobing (this way it can also happen in sync between the fixtures)