Soundswitch micro usb interface (beginner question)
Posted: Mon Oct 10, 2022 1:48 pm
Hello guys, I am new to all of this, but I have being doing as much research as I can before trying to get it to work for the first time.
In short, I don't know if my Enttec Open DMX USB is working? I have it setup, checked the outputs, but there is no response from my fixtures
The guy at the local DJ store sold me a SoundSwitch micro interface, and that works fine, but only with Soundswitch. I know that my fixtures are addressed and channeled correctly etc becasue they work fine with soundswitch, but I want to use QLC+ so I swtich over to the Enttec Open usb but I can't seem to get anything to happen after that. I have tried changing the output mode, frequency, addressing, re-installing etc but really not sure what I am missing?
I feel like I have a pretty good understanding of the software so far, with mapping the virtual console and general use of the fixtures - all Chauvet. I have been through every tutorial I can find on youtube and felt like I am ready to go, bought all the gear, but yea...
My aim is to use reaper and send midi commands to qlc+ via lookmidi, and I know I have all of that setup well etc.
I am very excited to dig into it all but can't seem to get this happening just yet. I have a new high-end laptop etc so I don't think it could be that I need the Enttex pro? - I hope not becasue I already have the soundswitch interface and the enttex open haha, orrrr is it possible to use the soundswitch micro interface with qlc+?
Any help would be greatly appreciated! Thank you
In short, I don't know if my Enttec Open DMX USB is working? I have it setup, checked the outputs, but there is no response from my fixtures
The guy at the local DJ store sold me a SoundSwitch micro interface, and that works fine, but only with Soundswitch. I know that my fixtures are addressed and channeled correctly etc becasue they work fine with soundswitch, but I want to use QLC+ so I swtich over to the Enttec Open usb but I can't seem to get anything to happen after that. I have tried changing the output mode, frequency, addressing, re-installing etc but really not sure what I am missing?
I feel like I have a pretty good understanding of the software so far, with mapping the virtual console and general use of the fixtures - all Chauvet. I have been through every tutorial I can find on youtube and felt like I am ready to go, bought all the gear, but yea...
My aim is to use reaper and send midi commands to qlc+ via lookmidi, and I know I have all of that setup well etc.
I am very excited to dig into it all but can't seem to get this happening just yet. I have a new high-end laptop etc so I don't think it could be that I need the Enttex pro? - I hope not becasue I already have the soundswitch interface and the enttex open haha, orrrr is it possible to use the soundswitch micro interface with qlc+?
Any help would be greatly appreciated! Thank you