Q Light Controller+

Hi Massimo,
slider in Submaster mode is not working:
. everything @ full;
. set the Submaster @ 50%
. the output doesn't change;
. move the dimmer and set it again @ full
. the output updates correctly.
Each time I've to move the dimmer slider to see the effect of the Submaster.

Attention to the monitor:
. everything back @ full;
. set the monitor at 50%;
. nothing happens;
. move the dimmer and the output doesn't go under 50%;
. reset the monitor and the output still doesn't go under 50%;
. to really reset the monitor I've to set it @ 0 and then push the reset button.
I guess it related to this:
viewtopic.php?f=35&t=15779

This doesn't work on v4 as expected too

[EDIT] ok, the issue is that v5 saves the slider level even if it's in monitoring mode, which cause to override some HTP channel.
I've done the submaster fix but the project needs to be fixed too.

How to fix the project?
I've prepared a workspace for a midi controller and I've already insert a new slider in Sub Master mode,
when I launch the cue with the sub at 0 the output stays at 0, when the sub is at full the output stays at full.

Okay I did a test with a new file and same problem like yesterday, the submaster is working only for sliders and not for buttons.
I'm using the last appimage and I've found a new bug as well: the button (scene) is driving also the slider (level mode) but the output does not update consequently.
The file has explanation notes inside.

I have fixed submaster control of VC Button.
There is still some misbehavior between the slider and the button I still need to figure out