Q Light Controller+

Hello community,
last week we've played again an "old" show in Grec Festival, Barcelona,
- I'm not Ashamed of My Communist Past -
Credits here:
https://www.barcelona.cat/grec/es/espec ... unist-past
They recorded the performance and here a little excerpt:
https://my.opendesktop.org/s/Jo3axdQzsSR5rNd

Very easy setup, originally with QLC+ 4.10.3 + open Enttec + NanoKontrol 2.
QLC+ has worked always very well, the weak point has been the time needed to make the necessary adaptation on each venue.
Have a good summer!

QLC+ is a very good software. Nice job.

Hi, I'm just starting with QLCplus. I'm already running it on an rpi with a DMX board from bitwizard. So far, everything works fine.
I own a Nanokrontol 2. I have the latest driver for Windows for that, but in qlcplus, only knobs seems to work a little, no sliders, no buttons. I have KORG nanoKONTROL 2 as input and Profile too.
Any ideas what I am missing?

Thijs, Welcome to the forum,

You will find quite some thread dealing with the nanocontrol.
In short: check emulation mode and midi settings inside QLC+.
Have a look here: viewtopic.php?t=11941