Q Light Controller+

Hi, I am watching Massimos tutorials and following along to setting up scenes. My lights are not responding as they are in the video. I’ve followed along and added my fixtures but they are not responding to the enabled channel sliders.

The lights respond when I switch back to simple desk and move the channel sliders.

Why are they not responding to the sliders in the scenes function?

Thank you!

Welcome to this forum.

You talk about switching back to simple desk -> I think there is your solution.
Simple Desk has upmost priority. When you touch the faders in simple desk, these channels are 'blocked' with values set by the simple desk.
Press the red X's so simple desk is switched free.
Now you will be able to preview your scenes again.

Another reason could be that your virtual console is in Run mode - red square near top right corner. If that's the case you have to explicitely deselect Blind mode in the scene editor (the icon showing slash across eye)