Udev error when my FX5 interface is connected

[KaHe10]

Hello everyone,
I would like to experiment with the QLC+5 Beta, but unfortunately I get the error message "Please assure that the udev rules are installed" again as long as one of my Digital Enlightenment FX5 interfaces is connected. Unfortunately, I can't do without the devices because they still have to work under DMXC. System is Windows 10.
I have the option of using Windows 10, 11, Linux or MacOS. Unfortunately, DMXC only works under Windows and I still have a lot of projects on it.

my devices
2 x Digital Enlightenment FX5
1 x Nodle R4S
1 x Showtec Net2/3 ArtNet
1 x Showtec Creator 2048 as input device

It works with the test version 4.12.5 and 4.12.3. With 4.14.4 and also with the 5 beta I always get the udev rules message and cannot start QLC+.

Is there a possibility, since the FX5 generally works?

greeting
Karsten

[mcallegari]

IIRC there's been a fix for FX5 on Windows. Still not released on QLC+ 5.
Please be patient.

[KaHe10]

Thank you, I guess I'll have to wait a little longer then. Too bad, I would have liked to tested the V5 before.

I'll try a switchable USB hub. So I can switch the interfaces on and off.

greeting
Karsten