Q Light Controller+

Hey, I am brand new to QLC and light programming, only using Lightrider in the past. I am moving along well in creating static scenes/collections, but I have hit a snag.
I have a Gigbar Move that has two moving heads, working in 35 channel mode. When I try to create EFX, to move the heads the action/selection only affects the left head. No movement at on with the right one. I am wondering if I have a selection button screwed up. Any suggestions?

The fixture does not have the heads defined. That's the reason you cannot use EFX on this multi-head fixture.
Rev2 version of the fixture in the annex.
Try this one, please.

The definition was possibly created before the multi-heads introduction into QLC+.