Q Light Controller+

Curious what the best way to do this is...

We want to run QLC on a mini-PC, which automatically boots and runs a show upon power-up. Ideally, we would also be able to trigger different shows from a Crestron system. So we have a couple of worlds to put together. Any ideas would be helpful!

Thanks,

_Mike

Mike, Welcome to the forum.

To start with: what O.S.?
With the parameters you can start QLC+ loading a project and go into produce mode thereafter automatically.
Please read how to: https://www.qlcplus.org/docs/html_en_EN ... eters.html

Inside your project, you have to define a startup function. Use the green flag and choose what has to happen at startup.
https://www.qlcplus.org/docs/html_en_EN ... nager.html

I'm not aware of what Crestron can send out but I find a lot of articles talking about Artnet - so now you can control QLC+ by Crestron signals.