QLC on Windows... again
Posted: Tue Dec 21, 2021 7:56 am
I've been aimlessly trying to compile QLC+ 4 on windows for the past couple days... I know it's a complete shit show but I figured as I'm using it on a Windows platform, the code I modify is no good to me if I can't compile it on the same platform. I've followed each step in the wiki page and I've gotten it past the MSYS make steps, but upon running the executable it throws errors that DLLs are missing. I copied the required DLLs from the mingw32 folder, and it now shows these errors:
This is on a fresh install of MSYS and a clean build. All unnecessary plugins have been disabled, and I am compiling in release mode.
Any thoughts on where I've gone wrong?
I do all my developing in Linux (thank heavens), and only need to be able to compile the executable for use on Windows.
Just wish Windows wasn't such a pain in the ass for compiling open-source.
Thanks all, sorry if this question is a dumb one. I've been scratching my head for much too long to keep on trying on my own.
Kyle
This is on a fresh install of MSYS and a clean build. All unnecessary plugins have been disabled, and I am compiling in release mode.
Any thoughts on where I've gone wrong?
I do all my developing in Linux (thank heavens), and only need to be able to compile the executable for use on Windows.
Just wish Windows wasn't such a pain in the ass for compiling open-source.
Thanks all, sorry if this question is a dumb one. I've been scratching my head for much too long to keep on trying on my own.
Kyle