Page 1 of 1
Bitwizard
Posted: Wed Nov 03, 2021 10:26 pm
by djtale2003
Hello, everyone,
Today I received the DMX interface from Bitwizard (the board does not have the FT245RL chip on board) and tried every manual that is available on the internet. I didn't make it. I have now reloaded the image. Can you please show me a current tutorial?
Re: Bitwizard
Posted: Thu Nov 04, 2021 7:53 am
by mcallegari
Re: Bitwizard
Posted: Thu Nov 04, 2021 10:22 am
by djtale2003
hello massimo,
many thanks for the quick response. I have tried to follow these instructions, but I do not understand why I should install qlc again when I have installed an image that was ready before you? The link for Harold van Hulten's howo is also no longer available. Do I even need OLA for the bitwizard?
Re: Bitwizard
Posted: Thu Nov 04, 2021 3:55 pm
by mcallegari
there is some notes in the official image PDF about bitwizard.
No help from there?
Re: Bitwizard
Posted: Thu Nov 04, 2021 5:21 pm
by djtale2003
in the description there is a link, but it is invalid. Which PDF do you mean?
Re: Bitwizard
Posted: Thu Nov 04, 2021 5:48 pm
by mcallegari
The PDF provided with the official QLC+ on the raspberry pi image
Re: Bitwizard
Posted: Fri Nov 05, 2021 12:51 pm
by djtale2003
Hi there,
I have no idea what I've done now, but it works after the 5th time uploading the image.
Thanks for the support
Re: Bitwizard
Posted: Tue Nov 09, 2021 10:59 am
by GGGss
By default, Bitwizard uses its XLR as an input (not output).
Did you instruct the Pi to set a high value to the GPIO output as needed?