Q Light Controller+

Hello Everyone,

I am currently setting up some raspberry pi's to automate some fixtures turning on and off. I am wanting to make it simple. I have created the file on my PC using a chase and then pressing the green flag (startup function) under the Functions tab and selecting the chase that I would like to have autostart. This is not working when I load it into the raspberry pi. Does anyone know how I can have a chase autostart on boot of the raspberry pi? Thanks!

There is a special procedure to have a show file start automatically on the Pi - you must upload the show file through the web interface, and then designate it to start up automatically, also through the web interface (on the system page)