Q Light Controller+

I have 8-ADJ Mega Hex pars and 6-Mega Hex batons. I'm using a DMX King ultraDMX Micro into generic wireless DMX transmitters/receivers. I have the fixtures in 11-channel mode. I have them added in the same mode in QLC+ (4.12.3). All are fixtures are in slave mode. I have control over all the colours but cannot control strobe, sound activation mode or any of the other functions available in 11-channel mode. I haven't had time to test with the fixtures individually addressed to se if that makes a difference. I have attached the scene file I've been using. Any insights into getting this sorted would be greatly appreciated. Thanks.

In your show file, you have a strobe scene. In the Strobe-on scene, nothing is entered. I'd connect a fixture (even better: 2) to see what the fixtures are outputting and then you can decide?

If you want all lights to strobe synchronously, you will have to create a fast chaser - something like 115ms on 115ms off (equals 130 bpm and flash on a bar)

Thank you for the reply.

G