Q Light Controller+

Hi there,
i'm running the QLC+ on my RPI installed it manualy.

I added the commande:
qlcplus --web --operate --overscan --open /root/.qlcplus/autostart.qxw

into the LXsession:
sudo nano /etc/xdg/lxsession/LXDE-pi/autostart

now QLC+ starts at boot but does not open the autostart file.

when running the command in the commande line (therminal) QLC+ start up and the autostart show is loaded.

i'm not a wizzard in linux so please in simple texst

regard,

Frans

Make sure that the user operates the 'automated' process has the same rights as the user you use when trying manually.
My eggs lay inside the 'rights' basket.

Thanks, this was the solution. use right was not set right.

regard,