Q Light Controller+

Hello, I try to achive something very simple: in passthrough mode, with midi note velocity values, sending certain dmx values out. The problem is, at every note end the note-off message sends out a 0 dmx value, which I do not want (do not want to reset the dmy value to 0)

I can not find how to disable sending out (0) dmx value at note-off midi message. Is it possible? (in passthrough mode)

It is so simple, maybe I'm missing something here, so I welcome any other (than the answer itself) ideas, comments regarding this too.

Thank you,

If you have an input profile assigned to the universe, see if disabling the checkbox in the input profile editor for "When midi notes are used, send a Note Off when value is 0" helps. I haven't seen this specific issue directly, but your description makes this a logical place to start.

- Mike

Yes, I tried that, but unfortunately it does not work that way.