Q Light Controller+

Hi all,

I'm using a korg nanokontrol2 with the enttec open usb dmx to control some 15 channel LED bricks. Is there a way to map the controller so the knobs control channels 1-8 on the simple console and the sliders to control channels 9-16? Or could the track buttons be mapped to cycle to the next 8 channels?

You cannot map knobs or sliders of the NanoKontrol2 to simple desk channels. You only map knobs and sliders to a controls in Virtual Console. You can use a frame in multipage mode with 8 sliders in it an cycle to different pages with track buttons, you have to enable "Catch up with the external controller input value" on each slider properties.
See the attached sample workspace. It has two representations of NanoKontrol 2 sliders, knobs and buttons, one in single page mode and one in multipage mode, slider #1 on both is GM. Try it and you will be able to adapt it to your needs.

Thank you kindly!