Page 1 of 1
Fade between RGB Matrix in Solo Frame
Posted: Thu May 14, 2020 12:12 pm
by gd360
Hey guys,
I have a solo frame with 16 different matrix programs for a led matrix.
When I klick on one matrix I get a very un-nice transition between the two - like a flash.
I wondered, if there is a possibilty to fade from one setting to another.
Any help appreciated,
Kind regards,
Gerhard
Re: Fade between RGB Matrix in Solo Frame
Posted: Thu May 14, 2020 2:20 pm
by edogawa
You can add fade times in the RGB Matrix editor by clicking the watch icon near the top.
Add Fade in and out times and the buttons in your solo frame should obey these.
I can only check with the DMX monitor currently, and it seems to work well that way.
Re: Fade between RGB Matrix in Solo Frame
Posted: Fri May 15, 2020 11:54 am
by gd360
Thanks for the reply,
but thats the fade in and fade out within the function.
So when I have a high fade-In a have a complete other function.
I wanted a fade from one matrix setting to another one in the virtual console.
Kind regards,
Gerhard
Re: Fade between RGB Matrix in Solo Frame
Posted: Sat May 16, 2020 12:58 pm
by mlohrey
This has been a problem in QLC+ for a long time. There are several threads discussing the issue. Fades between things that have fades in them aren't handled very well.
It must be quite a difficult thing to program otherwise it would have been resolved by now.
The only way you can do is put the matrix on a fader and then manually fade them up and down. If you have some kind of midi device this is achievable by very hard from a computer interface