Q Light Controller+

I'm going crazy...
I've created scenes, put them into a chaser and control the chaser with a cue list that is triggered by a Midi Note.
Whem I call the cue steps manually (by slider or with the < > arrow buttons) all works fine.
The DMX values are as expected

Blue scene MANUAL So far, so good.

When I switch to show mode an start the Midi track, the cue steps are triggered one after the other -as expected- but the scenes now look totally different:
In the DMX Monitor the values are now different:

Same Scene, Cue triggered by Midi I don't understand it. I've found nothing in the cue properties what could cause the difference.
Tried to use entries from a different chaser but it stays the same effect.
Where come these unexpected DMX values from?

I've cheched the scenes: they work as expected
I've checked the chaser: you can go forward or backward, works as expected.

No idea

Here ist the fixture I Use and some other scenes with the same effect:
Manual triggered Midi controlled

Hi,
In your project you have assigned the MIDI Channel 189 to next cue in the cuelis, but is assigned too to play another cuelist existing in your project.
Check unused/hidden cuelists.

sbenejam wrote: ↑Sun Mar 29, 2020 7:28 am Hi,
In your project you have assigned the MIDI Channel 189 to next cue in the cuelis, but is assigned too to play another cuelist existing in your project.
Check unused/hidden cuelists.

Yeah, you're right: I found a cue list in background which was triggered with the same note
Had a false perception about what is active and what not and I have forgotten what I habe tested in the past to learn about QLC+.
Thanks sbenejam, your answers -so far- lead to 100% problem solution

Is there an overview of what midi notes are used or can it only be found in the .xml?