Q Light Controller+

I did a quick search, and I couldn't really find anything about it. QLC seems to have a limit of 5 pages for a frame. Does anybody know how to change this maximum, or a way to get around it? I need at least 20 pages.

I'm using an APC40, and want to have the Clip Launch buttons "activate" a fixture, which is then mapped to the Track/Device control knobs, and perhaps the faders. I considered simply making a duplicate of those controls for each fixture, but QLC isn't letting me make the virtual console any larger (I can type in any number for the resolution, and it'll just revert to 1920x1080 no matter what).

Thanks!

There doesn't seem to be page limit.

What version are you using?

I could create 20 pages for a frame in MacOSX Mojave using versions 4.12.2 and 4.13.2 GIT of QLC+

I'm using 4.12.2 On Windows. I'll probably take a look and see a little later if I get the same problem on some of my other computers.

If I recall correctly, there was a point in time where I had more pages, but I don't think that was on the install of windows I'm on right now.

Update: Tried on my laptop, and had the same problem. Maybe it's a Windows only issue? If somebody else could confirm or disprove this, that'd be excellent.

I tested on my windows machine and discovered a bit of a weird bug.

If you go to frame properties and then change the number of pages to 20. Save the file and then re-open and all is good.

For some reason the drop down menu showing the page numbers isn't refreshed until you reopen. If you use the forward/reverse buttons you can move the new pages but they just don't have a label.

This seems to happen on other versions of QLC+ as well. I just didn't realise that saving solved the problem.

I am sure Massimo can sort this little bug out!