Q Light Controller+

Hey :)

First of all, my English might be a little bit off cause I’m from Germany, hope you’ll understand it anyways.
Alright, basically I launched the Fixture Creator on mi Pi 3B+ and Created a new fixture and saved it as NAMEHERE.qxf File in the default fixture folder. Then I launched QLC+ 4 on my Pi and tried to import it. I was in the correct folder but however QLC wants .qxfl Files as Fixture-Files but the Fixture-Editor only saves it as .qxf File. So my question is: how to get around that and import the .qxf fixture file to QLC or save fixture files as .qxfl?! Any ideas or solutions to this problem?

Thx for reading! A reply would be nice!

Have a great day everyone! :)

Hi, that's not right.
qxfl is a list of fixtures, qxf is a single fixture file.
Please check the documentation

Here is where I found all my Fixtures I created in Fixture Definition Editor. Granted that I installed the program by its default settings
(IN WINDOWS) Try going to your
click---> Local Disk (C:) drive
click---> Users
click---> (Your Computer Name) <--Mine is different
click---> QLC+
click---> Fixtures
You should see the saved (as) .qxf files you edited or created Fixture Definition Editor.

I hope this helps