Q Light Controller+

Hi,

I have just managed to install an LM3R Artnet to DMX interface in my house and I am using the Luminair app on the iPad to control the fixtures.
I am now trying to use the Mac in order to do the same job and replace the iPad. However, I am confused on how to deal with the whole setting up. It's above my knowledge to be honest. I have created the fixtures and a couple of scenes, but could do some help withe the following:

I have selected as output the Mac, and should I use as IP address the mac's, a unique one or the Artnet's?
I haven't activated any inputs
If I go to Nodes Tree I can see the Mac (192.168.1.2) and the Artnet Device (192.168.1.99) which I m sure it's good....
Passthrough selected (?)

Thanks in advance,

doberman wrote: ↑Sun Nov 10, 2019 11:51 pm the Luminair app
I am now trying to use the Mac in order to do the same job and replace the iPad.

Unknown app - so no support

QLC+ has to talk in unicast to your artnet-interface