Q Light Controller+

Loaded file just fine in Raspberry Pi manually. But when I try to get the file to autostart, and then I reboot the PI, the file crashes QLC+ The workfile is 1.5MB, so perhaps it is just too big, but I am running it on a RPi 3.

Where should I save images so they load correctly on autostart? Currently I have them loaded /root/.qlcplus/images/HERE (that is what the XML file shows, am I messing up the path?

I believe the problem stems from the location that I am using for the images for the RGB Matrix. (perhaps even the naming convention.) Will it cause problems if there is a space in the filename on the pi? What location should I save them in so that everything works correctly.

When I start the PI with the autostart of my file, sudo service qlcplus status returns "Active (exited)". However if I stop the service and start it again, it will then load properly....

I am just quite a bit confused. I have attached the files that I am using.