Q Light Controller+

Hi guys!

I am using QLC+ for the first time and so far I'm loving it.

Just one problem -

So I am using the latest version of the software with an Enttec USB Pro MKII and whenever I program a simple scene - once I click on it no matter what I do I can't turn it off without manually turning it off through the simple desk. Even if I create a simple button to toggle on/off it won't do anything to the scene - Unlike the videos I've seen from Massimo where you click off it - or hit escape, and the scene just stops. Mine keeps on going

The fixture is a basic Laser fixture I created the fixture profile for - and when pushing up the faders via the simple desk it behaves perfectly - but when I create a scene and adjust the light levels just like in Massimo's videos - it stays on.

Any idea what this could be? Help would be greatly appreciated!! Thank you.

Sounds like a HTP/LTP problem.
I guess the definition you created for the fixture is somehow wrong.
Color channels should be set to "Intensity" (therefore HTP)
If a channel is LTP, then what you see is expected.

Hello there. Did you find a solution to this problem?
I have the same problem with me laser.

If I change scene it stays on the last scene's laser.

Can you upload your project?

I have the same issue... I have a laser that I created a scene for, and when I toggle it on during playback, it turns on and works. However, when I toggle it off, it stays on until I go to simple desk and reset the values.

I fixed it with the HTP LTP settings thanks !