Page 1 of 1
Configuring the Network
Posted: Mon Jul 08, 2019 10:34 am
by ashishalexander
Hey guys. i am relatively new to the lighting world. I have a Lightech Artnet to DMx 2 controller. It is connected to my PC via ethernet directly. I am trying to control my LED PAR Cans using the software. I have managed to get the device detected but there is no output. I have attached some preview photos. I am using artnetominator to monitor the output. I Can see that there is signal output.
Re: Configuring the Network
Posted: Mon Jul 08, 2019 5:45 pm
by sbenejam
ashishalexander wrote: ↑Mon Jul 08, 2019 10:34 am
Hey guys. i am relatively new to the lighting world. I have a Lightech Artnet to DMx 2 controller. It is connected to my PC via ethernet directly. I am trying to control my LED PAR Cans using the software. I have managed to get the device detected but there is no output. I have attached some preview photos. I am using artnetominator to monitor the output. I Can see that there is signal output.
Can you post more details of your setup, OS, QLC+ version, your network configuration, a sample project file, ...?.