Q Light Controller+

Hi Community,

actually I have a lot of chasers which I switched in a solo frame with buttons, everything works fine.

Now I want to do some Flash-Szenes like "All Spots Blue" or "All Spots White and Red" with separate Buttons.

If I use them as normal buttons, it will work, stops the chaser and shows the Szene, but afterwards I have to activate a chaser manually again.
If I use them as flash-buttons, it will work, but did not stop the actual running chaser, this one is still going on and also changing the values of the spots.

Is it possible to realize my wish ... stopping an actual running chaser as long as I press the button and then it goes on again after releasing the button.

A little bit like this:
- pushing the flash-szene button
- the chaser stops at the actual position or stops complete, this is equal
- the spots are only showing the values from the flash-szene
- after releasing the button the same chaser runs again, from the last position or again from the beginning

Is something like that possible?

kind regards and thank you
Roger

My solution is to use two seperate callbacks - one inverted - to
stop and restart a cue...
Maybe the attached workspace might help you.