Q Light Controller+

Hi

I am getting myself very confused about click and go! I want to have a colour picker for an RGB fixture but I can't work out how to get it to work (using simple desk) bit there is nothing obvious here - the information I have found says it is already enabled in this. I looked in the fixture definition editor (the info says it starts here) but can't see anything about how to add it there either. I can add a colour wheel or macro, but that's obviously not right. Unfortunately there is not a lot in the manual about setting it up.

Any advice would be welcome.

Many thanks

As far as I understand, there's no RGB Click&Go in Simple desk. Right clicking a fader gives single colour Click&Go intensity bars and tables depending on the channel capabilities, so this part is there.

In VC, when editing slider properties, in level mode you can enable Click&Go, select the fixtures' R,G,B channels (or CMY, Gobo etc.) and corresponding Click&Go mode, and it will show the colour picker/Gobo selector etc.

Hope that helps

Resources are:
https://www.qlcplus.org/clickandgo.html
and
https://www.qlcplus.org/docs/html_en_EN ... l#channels

Then you can use Click & Go with Virtual console sliders in level mode

Thanks for the prompt reply. I did read the documentation on click and go, bit found it hard to follow I'm afraid. As it said click and go is automatically enabled in simple desk, I assumed it could control the colour of colour of the RGB channels. I will give the virtual console a go.

By "Click & Go is enabled by default on Simple Desk and Scene's sliders" I meant what you see in the screenshot.
Just click on the channel icon to display a Click & Go popup. Doesn't seem that hard to me.