Q Light Controller+

Hi,

I've got an issue in that the current venue I'm designing with has two lights running off each dimmer. Unfortunately, I've no way around this -- some lights will have to be 'paired'

I'm not on their site often, so using the visualiser is a must.

Is there any way of showing a fixture twice on the visualiser?

If that's not possible, I'm totally open to other 'bodge' suggestions!

Thank you!

Cormac

I can imagine a workaround; add a fake dimmer channels in an address range outside of what's used in reality the venue, e.g. same dmx addresses but in a disconnected universe, and add these to your VC widgets/functions etc.

Not sure if that would work, but may be worth trying.