Page 1 of 1
Moving Head makes what he want
Posted: Sun Mar 10, 2019 9:52 am
by werwe
Hello,
since last week, I have QLC+ 4.12.1. It is a very nice Software for DMX controlling.I have two lightmaXX EASY WASH TRI. When I want to create an Effect with the first one, it works. But when I want to create an Effect with the second one the first one go ape. He changes the colors and make himself. I can't control him.
What can I do?
Many Greetings.
Re: Moving Head makes what he want
Posted: Mon Mar 11, 2019 9:39 am
by GGGss
What interface do you use?
It might be necessary to lower it's output frequency. There a quit some post about that here...
Re: Moving Head makes what he want
Posted: Mon Apr 08, 2019 4:47 pm
by werwe
Hi,
sorry that I reply so late. I use the Enttec Open USB Interface.
Thank you for your help.
Re: Moving Head makes what he want
Posted: Tue Apr 09, 2019 8:38 am
by GGGss
Rereading your first post - I noticed a potential problem:
Did you use a correct DMX address for both of them?
If addresses would overlap - controlling #2 would influence #1.
Re: Moving Head makes what he want
Posted: Tue Apr 09, 2019 2:53 pm
by werwe
No, the addresses are both correct. It works, but only when I want to make a movement function, it doesn't work
Re: Moving Head makes what he want
Posted: Wed Apr 10, 2019 8:02 am
by GGGss
Can you make a little video of what is going on?
The definition: 'it doesn't work' is so vague - you might think: Is the powercord connected?
Re: Moving Head makes what he want
Posted: Wed Apr 10, 2019 8:38 am
by yokosuna
What happens when you switch adresse and/or position of the MH in the chain ?
Are both usinf the same "mode" (4CH, 12CH) ?
If everything is programmed correctly, I second that there is a electrical problem.
Have you ever tried using a terminator ? Chinese products tend - from time to time - to
be not assembled the way they should be...