Q Light Controller+

Hi, im fairly new to QLC and Im trying to create a fixture profile for a Martin MAC Quantum Wash, This lamp uses 16 bit address ranges for some of the effects presets between two channels.. how should I record these values in the channel editor?

Thank you.

https://www.qlcplus.org/docs/html_en_EN ... l#channels

See "Role"

Thanks, but that makes sense for pans and tilts and intensities etc, but the fixture im trying to create uses 16 bit ranges for programmed effects. I need to record the presets, not in 512 addresses, but in 16 bit. E.g.. 60400 - 60499= preset 1: beam 3.