Q Light Controller+

Hi. I have a problem and am not sure if it is something I am doing wrong or it is a bug.

If I load 'workspace 1' the Simple Desk works fine. But if I then load 'workspace 2', Simple Desk can not control the fixtures in it and raising and lower the dimmers shows nothing in Fixture Monitor 2D. However, if I switch to something like Functions or Virtual Console, the lights themselves work just fine and the monitor reflects the changes. At that point if I exit QLC, restart it and load 'workspace 2', then Simple Desk works fine again.

I can clearly live with this issue, but I'm a Newbie so I switch workspaces a lot depending on what I am trying to figure out.

QLC 4.12.1
Vista Home SP2 (do NOT laugh, it is my dedicated lighting and sound laptop)
uDMX
All fixtures are LED and the same in each workspace

Thanks
Jack

When you switch from 1 to 2 ... did you check inputs & outputs? Maybe something got overwriten there?

Nope, they look the same. And like I said, the lights work okay if I use something other than Simple Desk. Kind of strange I think, but then , it is software.
Thanks