IMG Stageline PARL-36DMX
Posted: Sun Feb 17, 2019 12:44 am
Tested with PARL-36DMX/CR. The /CR means Chrome finish so I would like to think the same fixture definition would work with other finishes.
Manual here:
https://www.manualslib.com/manual/12000 ... =11#manual
I have added aliases for the mode channels. Have I done them correctly? Is this triggering a bug in QLC+?
If I raise then lower channel 1 all looks good.
If I raise then lower channel 5 all looks good.
If I raise channel 1 then raise channel 5 then lower channel 5 then lower channel 1, the channel types go a bit wrong.
I think this happens because channel 1 affects the function of channels 2, 3 and 4 but channel 5 affects the function of channel 1 (and 2, 3 and 4).
If the problem isn't immediately obvious I'll try and explain it better and/or do some more investigation.
Manual here:
https://www.manualslib.com/manual/12000 ... =11#manual
I have added aliases for the mode channels. Have I done them correctly? Is this triggering a bug in QLC+?
If I raise then lower channel 1 all looks good.
If I raise then lower channel 5 all looks good.
If I raise channel 1 then raise channel 5 then lower channel 5 then lower channel 1, the channel types go a bit wrong.
I think this happens because channel 1 affects the function of channels 2, 3 and 4 but channel 5 affects the function of channel 1 (and 2, 3 and 4).
If the problem isn't immediately obvious I'll try and explain it better and/or do some more investigation.