Gents,
I have a problem with controlling the strobing with my 12x12W PAR Led module.
When i control the strobing channel (channel 6, low to high) when it is on 255 it doesnt strobe that fast. While i know it can strobe much faster in manual mode(buttons on the fixture).
So quite dissapointed I closed QLC+ and strobing suddenly went much faster. So i have been fiddling around with my udmx timings and channels before.
its now set on 255 channels with a frequency of 30Hz which seems to be working fine for me. But it doesnt seem to work with strobing.
The strobing works if i set my udmx timer to 1Hz. Probably because the messages come in correct and dont get overwritten half way trough.
But you cant control lights with a 1Hz DMx frequency.
Is there any way to fix this. It seems that my DMX controller in continously sending out messages what to do to the led. I think what I need is to send trough the "changes" when made. Is that possible to turn on somehow. Or did anyone had similar problems with these kind of issues?
QLC+ 4.11.2, standard workspace
uDMX light controller
Q Light Controller+
Official forums of the QLC+ project