Page 1 of 1
Channel reset buttons don't work on universes >1
Posted: Tue Jan 15, 2019 2:46 pm
by sparkyb
When I manually adjust a channel in the simple desk it turns red. On universe 1 when I click the X reset button below the channel it makes it not red and sets the level back to 0. However when I try this on any other universe it makes the channel not red, but it leaves the level where it was and does not set it back to 0 like it should. This is with 4.12.0.
Re: Channel reset buttons don't work on universes >1
Posted: Tue Jan 15, 2019 6:41 pm
by sbenejam
sparkyb wrote: ↑Tue Jan 15, 2019 2:46 pm
When I manually adjust a channel in the simple desk it turns red. On universe 1 when I click the X reset button below the channel it makes it not red and sets the level back to 0. However when I try this on any other universe it makes the channel not red, but it leaves the level where it was and does not set it back to 0 like it should. This is with 4.12.0.
I just tested this behavior on QLC+ 4.12.1 from git Ubuntu 18.04. Reset single channel make channel not red and channel value remain. Resetting with reset all channels work as expected.
Re: Channel reset buttons don't work on universes >1
Posted: Wed Jan 16, 2019 4:07 pm
by sparkyb
Oh hey, I never noticed that reset whole universe button before. Thanks. I'd still like the reset channel button to work correctly, but the reset universe button will be helpful as a workaround.
Re: Channel reset buttons don't work on universes >1
Posted: Fri Feb 08, 2019 8:47 am
by mcallegari
Issue fixed on git. Thanks for reporting.
Test versions available.