Page 1 of 1
Add settings for Universe - Subnet, Net
Posted: Thu Dec 20, 2018 3:03 pm
by bottle
Hi
I use ArtNet Nodes whith 4 outputs, but they are assigned to 1 Universe. I
If I choose 1 Universe, then
1 output is Universe 1, Subnet 1, Net 1
2 output is Universe 1, Subnet 1, Net 2
3 output - ...Net3
4 output - ...Net 4
I really like qlc, but for now I can only use 1 output ..
Can You add advanced settings for the Universes?
Re: Add settings for Universe - Subnet, Net
Posted: Thu Dec 20, 2018 3:09 pm
by mcallegari
Can you please share a link to the product page ?
Re: Add settings for Universe - Subnet, Net
Posted: Thu Dec 20, 2018 3:33 pm
by bottle
HALO brand,
it is not on the site now,
there is a version with 8 outputs
http://www.galo.com.ua/lighting/light_c ... 8_pro.html
Re: Add settings for Universe - Subnet, Net
Posted: Thu Dec 20, 2018 4:51 pm
by mcallegari
Well, usually ArtNet nodes like that distinguish DMX universes with the ArtNet universe ID, which is already transmitted by QLC+.
Just select the node on each universe you intend to use and that's it. Have you tried that ?
Re: Add settings for Universe - Subnet, Net
Posted: Thu Dec 20, 2018 11:24 pm
by bottle
I tried, only 1 output works.
This was their experimental model.
The controller has not web interface and has a static ip
Re: Add settings for Universe - Subnet, Net
Posted: Fri Dec 21, 2018 9:49 am
by mcallegari
That's weird.
Do you have a software that works with that device ?
If so, can you please capture with Wireshark the ArtNet network packets so that I can compare them to what QLC+ transmits ?
Re: Add settings for Universe - Subnet, Net
Posted: Sat Dec 22, 2018 8:24 am
by bottle
Yes,I connect it with jinx!
I'll try to deal with Wireshark
Thanks