Page 1 of 1
Artnet IP
Posted: Thu Nov 22, 2018 8:31 pm
by BMarchant
Hi,
When using an Artnet adapter, we currently send to only one device with fixed ip. When restarting QLC+ or when reactivating the Input/Output (we deactivate the plugin to prevent output changes when ending the program or when blind-adjusting some functions), this specific address always needs to be reconfigured in the plugin. Could this be stored somewhere?
Re: Artnet IP
Posted: Thu Nov 22, 2018 10:04 pm
by mcallegari
Which QLC+ version are you using ? You posted in the QLC+ 5 area. Is that intentional ?
The answer is no. When a plugin is deactivated, its settings are lost. Where on earth should QLC+ store parameters just because you intend to reactivate the plugin later ?
The "mind reading" feature in QLC+ is still missing...sorry
Re: Artnet IP
Posted: Fri Nov 30, 2018 9:12 am
by BMarchant
The "mind reading" feature in QLC+ is still missing...sorry
Since QLC+ can remember my show, it does mind-reading
The way I see it, the setting could be stored in the qxw-file like all other settings.
I use it mainly to disable output (while fixtures stay in memory-state) for changing a show so performers don't get disturbed when doing mass-changes during their repetition.
Or I use it at the end of the show before quitting the program when the last state should be holded because QLC+ black-outs all outputs before quitting.
In short, is there an output-hold functionality that pauses the output while changing scenes?
Re: Artnet IP
Posted: Fri Nov 30, 2018 12:07 pm
by mcallegari
BMarchant wrote: ↑Fri Nov 30, 2018 9:12 am
The "mind reading" feature in QLC+ is still missing...sorry
Since QLC+ can remember my show, it does mind-reading
The way I see it, the setting could be stored in the qxw-file like all other settings.
I use it mainly to disable output (while fixtures stay in memory-state) for changing a show so performers don't get disturbed when doing mass-changes during their repetition.
Or I use it at the end of the show before quitting the program when the last state should be holded because QLC+ black-outs all outputs before quitting.
In short, is there an output-hold functionality that pauses the output while changing scenes?
In QLC+ 5, yes. There's a pause button on output lines.
Re: Artnet IP
Posted: Fri Nov 30, 2018 1:58 pm
by GGGss
Bruno,
I just wrote an answer somewhere else:
viewtopic.php?f=18&t=12852
I use extra hardware for this exact purpose...