Fader sendinge lowest Value.
Posted: Sat Nov 10, 2018 5:22 pm
Hi QLC Folks,
Im new to QLC and probabbly have a very basic problem.
Scene:
lets take the shutter, its controlled as follows:
0 : OFF
0 - 135 : Shutter
136 - 247 : Strobe
So i create two buttons, ON and OFF and two fader, Shutter and Strobe with Shutter having Range 0-135 and Strobe 136-247
My Problem:
The fader: "Shutter" is sending its base Value; 136 all the time, even if i read the channel and have it update.
This also applies for lets say the Gobo Spin Speed. how would i go about having a Knob controlling the speed in the left direction and not collide with the knob controlling the speed of the right side.
Thanks in advance for the Help
Greetings Eddie
Im new to QLC and probabbly have a very basic problem.
Scene:
lets take the shutter, its controlled as follows:
0 : OFF
0 - 135 : Shutter
136 - 247 : Strobe
So i create two buttons, ON and OFF and two fader, Shutter and Strobe with Shutter having Range 0-135 and Strobe 136-247
My Problem:
The fader: "Shutter" is sending its base Value; 136 all the time, even if i read the channel and have it update.
This also applies for lets say the Gobo Spin Speed. how would i go about having a Knob controlling the speed in the left direction and not collide with the knob controlling the speed of the right side.
Thanks in advance for the Help
Greetings Eddie