Page 1 of 1
Adjusting physical properties of Generic RGB panel
Posted: Tue Oct 09, 2018 10:41 pm
by hypernurd
Dear Community,
Does anyone have an ideal how I can change the physical dimensions of the built-in RGB Panel (5x1 LEDs) so I can make it bigger in the DMX Visualiser? I've had a poke about the application package contents and there is a folder for fixtures (the one's QLC+ ships with) but the required item is not there.
Thanks in advance.
Hypernurd
Re: Adjusting physical properties of Generic RGB panel
Posted: Tue Oct 09, 2018 10:46 pm
by hypernurd
hypernurd wrote: ↑Tue Oct 09, 2018 10:41 pm
Dear Community,
Does anyone have an ideal how I can change the physical dimensions of the built-in RGB Panel (5x1 LEDs) so I can make it bigger in the DMX Visualiser? I've had a poke about the application package contents and there is a folder for fixtures (the one's QLC+ ships with) but the required item is not there.
Thanks in advance.
Hypernurd
Sorry all, should have been more specific.
When you create an RGB matrix, you specify the physical properties. However, once created you can't (as far as I can tell) change them.
Anyone have any ideas? I've created a large amount of fixture groupings with my panels - I'd rather not have to recreate them !!!
Hypernurd
Re: Adjusting physical properties of Generic RGB panel
Posted: Wed Oct 10, 2018 9:00 am
by GGGss
Those values are included inside your projectfile ... so make a backup first and then open it with the text editor of your choice...
You'll see it's a xml formated file. Be carefull not to break it (therefore the backup)
The width and height property of your panel are inside the fixture definition.
Re: Adjusting physical properties of Generic RGB panel
Posted: Wed Oct 10, 2018 3:21 pm
by hypernurd
GGGsss - you are a wonderful person
